July 26, 2023

Rogers AD300D PTFE Antenna Laminate

Rogers AD300D is a PTFE-based circuit laminate developed for RF and antenna applications. Its construction and controlled electrical properties support printed circuitry used in wireless infrastructure. It is part of the AD laminate family, rather than a home-audio amplifier.

Low dielectric loss and passive intermodulation performance are relevant considerations for antenna feed structures. They must be evaluated with the chosen copper, conductor geometry and complete assembly. A material test result cannot establish the PIM performance of connectors, joints or an entire antenna.

Use the data for AD300D specifically. Published process and design dielectric values can differ because they serve different purposes and use different methods. The article therefore does not assign a single unqualified dielectric constant to every construction. Review PTFE fabrication requirements with the manufacturer, including drilled-hole surface preparation, plating and the bonding system for a multilayer design. Confirm any proposed substitution through electrical analysis and the actual fabrication stackup.

Selection and validation

Before releasing a board, record the exact material designation, dielectric thickness, copper foil, finished stackup and inspection requirements. Have the fabricator review the construction and confirm material availability. Prototype measurements should establish whether the finished circuit meets its electrical and environmental requirements.

Official sources: Rogers AD300D product information.

Put this into production

Request a material, stackup and manufacturing review for your RF PCB project.

Get a Quote

Leave a technical comment

Your email address will not be published. Required fields are marked *